MR.ROCKAPES 20 MINUTE SPOOL!!!

[MR.ROCKAPE]

A BIT OF A TECH WRITE-UP FOR YOU CHEAP MUTHA-FAWKERS!!!

START WITH ONE OF THESE!!!
http://i28.photobucket.com/albums/c233/rockape81/100_0276.jpg

CUT TWO PIECES OF 1/4INCH PLATE LIKE THESE!!!
http://i28.photobucket.com/albums/c233/rockape81/100_0273.jpg
GET YOU AN OPEN TOYOTA CARRIER LIKE THIS!!!
http://i28.photobucket.com/albums/c233/rockape81/100_0271.jpg

[MR.ROCKAPE]

ADD THE LITTLE PLATES THAT YOU PRECISION CUT TO THE CARRIER LIKE THIS!!!

http://i28.photobucket.com/albums/c233/rockape81/100_0272.jpg

TURN YOUR LARGE MIG LIKE THE ONE PICTURED ABOVE TO BLITZKRIEG!!!AND WELD THE PLATES IN LIKE THIS!!!(REMEBER TO MAKE SURE THE PLATES WONT INTERFERE WITH THE AXLE SHAFTS BEING ABLE TO GO BACK INTO THE SIDE GEARS!!!)

http://i28.photobucket.com/albums/c233/rockape81/100_0274.jpg

REPEAT ON THE OTHER SIDE,CLEAN THE WELDING BBs AND RE-INSTALL INTO YOUR RIDE!!!
THIS IS THE STRONGEST METHOD,IF YOU JUST WELDED THE SIDE GEARS TO THE CASE IT WILL BREAK,FOR THIS TO BREAK YOU WILL HAVE TO BREAK 8 WELDS TO GET THE PLATES TO FALL OUT!!!!ALSO THE GEARS ARE WELDED IN THE CORNERS WHERE THE SIDE GEARS MEET THE SPIDERS!!!!!

[BIG BLUE]

can i use jb weld instead of a welder???:buttkick: that sucks i spent 500 buying a locker and I could have spent it on a welder....

Besides I heard STV in BFE showed you how to do that....

[Scrub]

ooooo.....whats the best way to get the c-clips back in after a project like this????? :crazy:

[MR.ROCKAPE]

ooooo.....whats the best way to get the c-clips back in after a project like this????? :crazy:

IF YOU NEED TO DO THIS TO A C-CLIP AXLE,YOU CAN CUT OUT RELIEFS IN THE SIDES FOR C-CLIPS!!!

[Scrub]

it was a joke.......

[MR.ROCKAPE]

it was a joke.......

I FIGURED, BUT YOU NEVER CAN TELL WITH YOU XJ GUYS!!!:buttkick:

[Scrub]

:fight:

[L.D.]

I FIGURED, BUT YOU NEVER CAN TELL WITH YOU XJ GUYS!!!:buttkick:

i understand that on an XJ, you can just use duct tape:mulletsmile: