motor mounts

[redneck6]

mr rockape would you like to fab me some motor mounts to place a 350 in a yj or any other takers on this i dont like what novak or advance makes
it is a few months out for needing them but figured i would ask early
http://i122.photobucket.com/albums/o247/redneck6_photos/07.jpg

sumphen like this with maybe 2x3 rec tubing that goes to frame ?


.:Big Grin::Big Grin::rolleyes:

[MR.ROCKAPE]

I JUST TAKE 2X3 ADD A PIECE OF 1/2 INCH INSIDE DIA TUBE AND USE STOCK GM MOUNTS(USUALLY THE URATHANE ONES THEY SELL AT SUMMIT....)FIGURE THAT WAY IF i BREAK ONE i CAN GET A REPLACEMENT AT ANY 7-11!!!!:Big Grin:ILL GET YA A PIC TONIGHT OF WHAT I DO.....BUT WELDING TO THE STOCK FRAME IS REQUIRED!!!!BUT MINE LET YOU POSITION THE ENGINE WHERE EVER YOU WANT...(USUALLY OFFSET TO THE OPPOSITE SIDE OF THE FRONT DRIVELINE FOR CLEARANCE!!!)

[redneck6]

thank you in advance , that is why i was asking you i just was hoping to get better and stronger then advance or novak , gusse i could go with m.o.r.e but i am lazy lol

[MR.ROCKAPE]

THESE ARE THE ONES ON MY TWO SEAT BUGGY....(4.3 V6 BUT WOULD BE THE SAME FOR A SBC)

http://i242.photobucket.com/albums/ff100/ROCKAPEJR/100_1664.jpg

WITH MOUNTS LIKE THIS...

http://store.summitracing.com/partdetail.asp?autofilter=1&part=ENS%2D3%2D1114G&N=700+4294908216+115&autoview=sku

BUT ALL IT IS ,IS A 2X3 .120 SQ TUBE CUT AT A 40 DEG ANGLE,THE CORRECT SIZE HOLE DRILLED THROUGH IT,A PIECE OF TOOB INSERTED,WELDED,THEN FIT TO THE FRAME AND WELDED IN!!!oF COARSE MINE ARE TIED TOGETHER WITH A PIECE OF 1.5 .120 ROUND TOOB UNDER THE OIL PAN FOR ADDED STRENGTH.

[L.D.]

thank you in advance , that is why i was asking you i just was hoping to get better and stronger then advance or novak , gusse i could go with m.o.r.e but i am lazy lol

why not stop by my place an take a look at my motor mounts. easy to make and strong.

[redneck6]

that is true but i am missing a welder or any real fab tools , that is why i was asking open ended ? if he or any one wanted to make them for me . :frown: