Hub studs

[NVScouter]

Fawking around in 2x4 (front only) I sheered all the hub bolts on my Warn Premium hubs.

I've read about companies machining studs into them, I have a fist full of G8 bolts to replace the G5's that sheered. Thinkning about the future, and I'm sure I'll think about it more as I work out all those POS sheered bolts tomorrow.

[MR.ROCKAPE]

Fawking around in 2x4 (front only) I sheered all the hub bolts on my Warn Premium hubs.

I've read about companies machining studs into them, I have a fist full of G8 bolts to replace the G5's that sheered. Thinkning about the future, and I'm sure I'll think about it more as I work out all those POS sheered bolts tomorrow.

BOLTS SUCK IN THAT APPLICATION!!!GET SOME STUDS(R&E FASTENER HAS WHAT YA NEED!!)...USED TO HAVE THE SAME PROBLEM WHEN I HAD MY OLD CJ5 ON 33s.....:eek:ADDED STUDS AND NEVER HAS A PROBLEM AGAIN!!!

[NVScouter]

Did you counter sink the hubs for a tapered nut?

[MR.ROCKAPE]

Did you counter sink the hubs for a tapered nut?

NO...JUST LOCK WASHERS

[rusty_tlc]

Isn't there a guy making uber strong hub studs?
I seem to remember seeing something about them when I was looking at Longfield hub clutch rings.

[NoBrainR]

Isn't there a guy making uber strong hub studs?
I seem to remember seeing something about them when I was looking at Longfield hub clutch rings.

Front Range Off Road sales a set of ARP studs for toyotas. Plus Hendrix will drill your hubs to add extra dowel pins. I'm sure there's a few good machine shops around here that could do it for you too.

[NVScouter]

Fuck EZ outs and I hope the inventor had his nuts fall off due to cancer.

I got 3 of 6, and the other 2 have drill bits and broken EZout chunks in them.

When I get back from Cheesehead land I'll work on it more.

[rusty_tlc]

Fuck EZ outs and I hope the inventor had his nuts fall off due to cancer.

I got 3 of 6, and the other 2 have drill bits and broken EZout chunks in them.

When I get back from Cheesehead land I'll work on it more.

EZ outs are the debil:mad: