1975 FJ40 knuckles w birfs and inners

[rusty_tlc]

Complete knuckles/ drums/ warn hubs and inner axles.
All the stuff left over from my mini truck knuckle conversion.

If no one hauls it away it's going for scrap.

[MR.ROCKAPE]

Complete knuckles/ drums/ warn hubs and inner axles.
All the stuff left over from my mini truck knuckle conversion.

If no one hauls it away it's going for scrap.

:hijack:

DO YOU HAVE ANY TRICKS FOR KNUCKLE BALL REMOVAL??? ......JUST GRIND??........:pissed:

[rusty_tlc]

:hijack:

DO YOU HAVE ANY TRICKS FOR KNUCKLE BALL REMOVAL??? ......JUST GRIND??........:pissed:
I didn't replace the ball, all it takes is a little work with a die grinder to clearance the inside of the ball for the toy truck birfields.

If your doing a cut and turn just use and angle grinder and go slow.
Chicago rented a big ass pipe cutter for his c&t and wound up using an angle grinder IIRC.

[slvrbck]

HE MEANS COMPLETE REMOVAL. HE HAS TO CUT THE KNUCKLE BALLS OFF A HOUSING AND WELD THEM ONTO THE NEW RUFF STUFF HOUSINGS.

I SAY, GRIND AWAY....CAREFULLY!!!

[rusty_tlc]

HE MEANS COMPLETE REMOVAL. HE HAS TO CUT THE KNUCKLE BALLS OFF A HOUSING AND WELD THEM ONTO THE NEW RUFF STUFF HOUSINGS.

I SAY, GRIND AWAY....CAREFULLY!!!
Same difference. Once you cut the weld the whole inner section should slide out, I assume you would want that part to make alignment in the new housing easier.
So how about you? Interested in a vintage set of course spline Birf's? I'll throw in a set of inner axles free.

If I can't get somebody to haul this shit away it's heading to the salvage yard.